EUROM Force 3000 IND Mode D'emploi page 48

Clean the floor cleaner
1. Make sure the device is off.
2. Remove the water supply.
3. Pull the floor cleaner
from the extension lance
(Figure 26, pos. 2).
4. Clean both nozzles
the cleaning pin
5. Flush them thoroughly (against the direc­
tion of the high-pressure jet).
Troubleshoot
CAUTION
Contact a EUROM authorized professional:
• in the event of regularly recurring errors;
• if the errors are not solved.
The following problems can occur:
Problem
The device does
not start.
Fluctuating
pressure.
48
(Figure 44, pos. 1)
(Figure 44, pos. 2) with
(Figure 44, pos. 3).
Cause Solution
Plug not in Plug the power plug into the
the power socket.
outlet.
Power outlet Use another power outlet.
not working.
Extension Contact a EUROM authorized
cord broken. professional.
Pump is suck­ Contact a EUROM authorized
ing in air. professional.
Valves are Contact a EUROM authorized
dirty, worn or professional.
broken.
Pump seal Contact a EUROM authorized
work. professional.
Figure 44.
Safety instruction
Make sure the device is off.
Make sure the device is off.
Do not use the device.
Do not use the device.
Do not use the device.
Do not use the device.