Publicité
Les langues disponibles
Les langues disponibles
● Check the mowing plan and change as
necessary. (
11.6)
● Switch on automatic mowing (
● MI 422 PC:
If necessary, activate GPRS energy
mode (
11.11) and switch on GPS
protection. (
5.9)
16.9 Removing the docking station
The docking station can also be removed
if the robotic mower is to be stored for
long periods (e.g.winter break).
● Preparing the robotic mower for storage
for a long period (
16.8)
● Disconnect the power supply unit plug
from the mains
● Remove the docking station cover and
open the panel (
9.2)
1 Fold open the left clamping lever (1).
2 Remove the left wire end (2) from the
terminal block.
Close the clamping lever (1) again.
3 Fold open the right clamping lever (3).
0478 131 9935 C - EN
4 Remove the right wire end (4) from the
terminal block.
Close the clamping lever (3) again.
11.5)
● Close the panel (
● Guide the left and right wire ends out of
the docking station separately from
each other
● Fit the docking station cover (
Pull out the pegs (1), remove the docking
station (2) from the lawn with the power
supply unit connected, clean thoroughly
(with a moist cloth) and put into storage.
● Store the robotic mower together with
the docking station and the power
supply unit in the normal position and in
a dry, closed and dust-free room. Dock
the robotic mower in the docking
station. Make sure that the machine is
kept out of the reach of children.
● Protect the terminals of the perimeter
wire from environmental influences
(e.g. wrap with suitable insulating tape).
● Reinstall the docking station in the
same way as during initial installation –
in particular connect the right and left
perimeter wire ends on the correct
9.2)
sides. (
17. Standard spare parts
9.2)
Mowing blade:
6301 702 0101
18. Accessories
Installation kits:
iKit S for mowing areas up to 500 m
6909 007 1011
iKit L for mowing areas from 2000 m
4000 m
6909 007 1012
Fixing pins AFN 075:
6301 007 1010
Perimeter wire ARB 501:
Length: 500 m
Diameter: 3,4 mm
0000 400 8625
Wire connector ADV 010:
6909 007 1090
Small-area module AKM 100:
6909 007 1016
Additional accessories are available for
the machine.
Further information is available from your
VIKING specialist dealer, on the internet
(www.viking-garden.com) or in the
VIKING catalogue.
9.8)
2
For safety reasons, only
accessories approved by VIKING
may be used with the machine.
2
2
–
151
Publicité
