Publicité
Les langues disponibles
Les langues disponibles
Install the guide loop in the lawn area as
illustrated. The perimeter wire (1) must be
fastened to the ground with two fixing pins
at the edge A and must not be crossed.
Minimum length: 100 cm
Width: 1 cm
● Attach the guide loop to the ground with
a sufficient number of fixing pins.
12.12 Accurate mowing along edges
At a track offset of 6 cm, a strip with
a width of up to 20 cm is left
unmown along high obstacles. If
necessary, edging stones can be
laid around high obstacles.
Minimum width of edging stones:
140
Route perimeter wire (1) at a clearance of
22 cm to the obstacle. To ensure that the
lawn edge is mown completely, the edging
stones must have a width of at least 20 cm
(clearance B). If wider edging stones are
laid, the lawn edge is cut even more
precisely.
Route the perimeter wire with a
greater clearance to the edging
stones around exterior and interior
corners. (
9.9)
Use wider edging stones if
necessary.
12.13 Sloping terrain in the mowing
area
In order for the robotic mower to
automatically mow a slope in the mowing
area (incline up to 15°) without any trouble,
the perimeter wire must be installed in the
slope with a minimum clearance to the
edge of the incline.
Slope with an incline of 5° - 15°:
If there is a slope with an incline of 5° - 15°
in the mowing area, the perimeter wire can
be routed below the top edge of the slope
in the slope as shown. The minimum
clearance (0,5 m) from the top edge of the
slope to the perimeter wire must be taken
into account for trouble-free operation of
the robotic mower.
Slope with an incline > 15°:
If there is a slope with an incline > 15° in
the mowing area, it is recommended to
route the perimeter wire (1) in the flat area
before the top edge of the slope. The top
edge and area of the slope are not mown.
0478 131 9935 C - EN
Publicité
