Viking MI 422 PC Manuel D'utilisation page 145

The mowing duration corresponds to the
time during which the robotic mower mows
the lawn. Times during which the battery is
charged are not part of the mowing
duration.
During initial installation, the robotic
mower automatically calculates the
mowing duration based on the specified
size of the mowing area. This reference
value is based on a normal lawn under dry
conditions.
Mowing performance:
2
For 100 m , the robotic mower needs on
average:
MI 422:
MI 422 P, MI 422 PC:
14.5 Home area (MI 422 PC)
The robotic mower identifies its location
using the built-in GPS receiver. During
each edge following run to check the
correct wire routing ( 9.12) and when
entering in the starting points (
the robotic mower stores the coordinates
of the most westerly, easterly, southerly
and northerly point.
This area is defined as the home area and
the robotic mower can be used here. The
coordinates are updated each time edge
following is repeated.
When GPS protection is activated, the
owner of the machine is notified if the
machine is operated outside the home
area. The PIN code is also requested on
the robotic mower display.
0478 131 9935 C - EN
15. Operating the machine
15.1 Preparation
An installation assistant is available
for initial installation. (
● Install the docking station (
● Route the perimeter wire (
connect (
● Remove foreign bodies (e.g. toys,
tools) from the mowing area.
● Charge the battery (
120 minutes
100 minutes
● Set the time and date (
● Check the mowing plan and adapt if
necessary – in particular it must be
ensured that third parties keep away
from the danger area during active
times. (
Mow very high grass until it is short
using a conventional lawn mower
11.15),
prior to use of the robotic mower
(e.g following a lengthy break).
15.2 Flap
The robotic mower is equipped with a flap
which protects the display from the
weather and from inadvertent operation. If
the flap is opened during use of the robotic
mower, operation is stopped and the
mowing blade and robotic mower come to
a standstill.
9.)
9.8)
9.9) and
9.10)
15.7)
11.11)
11.6)
Opening the flap:
For safety reasons, the Stop button
must be pressed before opening
the flap during operation of the
robotic mower.
Grasp the flap (1) at the lifting point (A)
and release upwards by pulling lightly.
Open the flap as far as the stop.
The opened flap can be removed
upwards from the machine. This
design is implemented for safety
reasons: This ensures that the
machine cannot be lifted and
carried by the flap.
Closing the flap:
Carefully fold the flap downwards and
allow to engage.
The robotic mower can only be
operated when the flap is fully
engaged.
15.3 Adapting the programming
The current programming can be seen in
the Mowing plan or, in the case of model
MI 422 PC, in the iMow app. ( 11.6)
143