Publicité
Les langues disponibles
Les langues disponibles
Insert the puller (F) and turn anti-clockwise
to the stop.
Support the machine with one hand.
Remove the carrier plate (1) by pulling on
the puller (2).
0478 131 9935 C - EN
Installing the carrier plate:
Thoroughly clean the blade shaft (1) and
the mounting on the carrier plate (2). Push
the carrier plate as far as possible onto the
blade shaft.
● Install the mowing blade. (
16.7 Finding a wire break
In the event of a wire break, the red
LED on the docking station flashes
rapidly. (
13.1) A corresponding
message appears in the display of
the robotic mower.
If a wire break cannot be found as
described, contact your specialist
dealer.
● Before finding the wire break, the button
on the docking station must be pressed
once (LED continues to flash rapidly).
● Remove the docking station cover and
open the panel. (
9.2)
1 Fold open the left clamping lever (1).
2 Remove wire end (2) from the terminal
block and then close clamping lever again.
● Open the panel and fit the docking
station cover. (
The following instructions describe how to
search for a wire break in a clockwise
16.4)
direction, i.e. the perimeter wire is followed
in a clockwise direction starting at the
docking station. If necessary, the search
can also be carried out anti-clockwise, but
in this case the right wire end must be
removed from the terminal block.
● In the "Service" menu, select the "Find
wire break" entry and confirm OK.
(
11.17)
9.2)
149
Publicité
