Publicité
Les langues disponibles
Les langues disponibles
● select the required starting point and
define it manually.
Teaching in starting points:
After pressing the OK button, the
robotic mower begins a new
learning run along the perimeter wire. If it
is not docked, it first travels to the docking
station. All the existing starting points are
deleted.
MI 422 PC:
The home area of the robotic
mower is defined during the
learning run. If necessary, a home
area already stored in the memory
is extended. (
14.5)
During travel, up to 4 starting points can be
specified by pressing the OK button after
opening the flap.
Avoid pressing the STOP button
before opening the flap as this
interrupts the learning run.
Interruption is generally only
necessary to change the wire
position or remove obstacles.
Interrupting the learning procedure:
Manually – by pressing the STOP button.
Automatically – by obstacles at the edge of
the mowing area.
● If the learning run has been interrupted
automatically, correct the position of the
perimeter wire and remove any
obstacles.
● Check the position of the robotic mower
before continuing the learning run. The
machine must either be located on the
perimeter wire or within the mowing
area with the front facing the perimeter
wire.
Ending the learning procedure:
Manually – following an interruption.
Automatically – after docking.
130
After docking or after the interruption, the
new starting points are saved by
confirming with OK (after opening the flap).
Starting frequency:
The starting frequency defines how often a
mowing operation is to begin from a
starting point. The default setting is 2 of 10
mowing operations (2/10) at each starting
point.
● Change the starting frequency as
required after learning.
● If the learning procedure has been
aborted prematurely, send the robotic
mower back to the docking station via a
command. (
11.5)
● MI 422 PC:
A radius from 3 m to 30 m around each
starting point can be defined after
learning. The stored starting points are
not assigned any radius as standard.
Starting points with radius:
When the mowing operation is
started at the respective starting
point, the robotic mower starts by
mowing the partial area within the
circular segment around the
starting point. Only then does it
mow the rest of the mowing area.
Setting starting point 1 to 4
manually:
Determine the distance of the
starting points from the docking
station and define the starting
frequency.
The distance corresponds to that
covered from the docking station to
the starting point in metres, measured in a
clockwise direction.
The starting frequency can be between 0
of 10 mowing operations (0/10) and 10 of
10 mowing operations (10/10).
MI 422 PC:
A Radius from 3 m to 30 m around the
starting point can be defined.
The docking station is
defined as starting point 0;
mowing operations are
started from here as standard.
The starting frequency corresponds
to the calculated residual value of
10 out of 10 operations.
11.16 Safety
1. Disab. device
2. Level
3. GPS protection (MI 422 PC)
4. Change PIN code
5. Start signal
6. Alarm signal
7. Menu signal
8. Child lock
9. Keylock
10.Link iMow and dock
1. Disab. device:
The disabling device is activated
with OK; the robotic mower can no
longer be operated.
The robotic mower must be disabled prior
to any maintenance or cleaning work, prior
to transportation and prior to inspection.
(
5.2)
● To deactivate the disabling device,
press the illustrated button
combination.
0478 131 9935 C - EN
Publicité
