Publicité
Les langues disponibles
Les langues disponibles
Risk of injury!
Strong vibration is normally an
indication of a fault.
In particular, the robotic mower
must not be operated with a
damaged or bent blade shaft or
mowing blade.
If you do not have the appropriate
expertise, have the necessary
repairs carried out by a specialist
dealer (VIKING recommends
VIKING specialist dealers).
Before leaving the machine unattended,
the safety settings of the robotic mower
must be adapted so that it cannot be
operated by unauthorised persons.
(
11.16)
Do not lean forward and always ensure
that you maintain your balance and a firm
footing on inclines when operating the
machine and its peripherals. Always walk,
do not run.
6.9 Maintenance and repairs
Before starting cleaning, repair
or maintenance operations,
activate the disabling device
and park the robotic mower on
firm and level ground.
Disconnect the mains plug of
the power supply unit before
performing any work on the
docking station and the
perimeter wire.
Allow the robotic mower to cool down for
approx. 5 minutes before performing any
maintenance operations.
The power cable must only be repaired or
replaced by authorised electricians.
102
Following any work on the machine, check
and, if necessary, correct the
programming of the robotic mower before
putting it back into operation. In particular,
the date and time must be set.
Cleaning:
The complete machine must be cleaned
carefully at regular intervals. (
Never spray water (particularly
high pressure cleaners) onto
motor components, seals,
electric components or bearing
points. This may result in damage and
expensive repairs.
Do not clean the machine under running
water (e.g. using a garden hose).
Do not use aggressive cleaning agents.
These can damage plastics and metals,
impairing the safe operation of your
VIKING machine.
Maintenance operations:
Only maintenance operations described in
this instruction manual may be carried out.
Have all other work performed by a
specialist dealer.
If you do not have the necessary expertise
or auxiliary equipment, please always
contact a specialist dealer.
VIKING recommends that you have
maintenance operations and repairs
performed exclusively by a VIKING
specialist dealer.
VIKING specialist dealers regularly attend
training courses and are provided with
technical information.
Only use tools, accessories or
attachments approved for this machine by
VIKING or technically identical parts.
Otherwise, there may be a risk of
accidents resulting in personal injury or
damage to the machine. If you have any
questions, please consult a specialist
dealer.
The characteristics of original VIKING
tools, accessories and spare parts are
optimally adapted to the machine and the
user's requirements. Genuine VIKING
spare parts can be recognised by the
16.2)
VIKING spare parts number, by the
VIKING lettering and, if present, by the
VIKING spare parts symbol. On smaller
parts, only the symbol may be present.
Always keep warning and information
stickers clean and readable. Damaged or
missing stickers must be replaced by new,
original plates from your VIKING specialist
dealer. If a component is replaced with a
new component, ensure that the new
component is provided with the same
stickers.
Only perform work on the cutting unit when
wearing thick work gloves and exercising
extreme care.
Ensure that all screws and nuts, especially
all screws and fastening elements of the
cutting unit, are securely tightened, so that
the machine is in a safe operating
condition.
Check the entire machine for wear or
damage on a regular basis, particularly
before extended periods when the
machine is not in use (e.g. over winter).
For safety reasons, worn or damaged
parts must be replaced immediately to
ensure that the machine is always in a safe
operating condition.
Components or guards that are removed
for maintenance operations must be
properly reinstalled immediately.
0478 131 9935 C - EN
Publicité
