Publicité
Les langues disponibles
Les langues disponibles
● Connect the power cable to the docking
station. (
9.3)
● Route the power cable under the floor
plate when the docking station is
installed at a wall. (
9.1)
Fix the docking station (B) into position at
the chosen location using four pegs (E).
● Install the power supply unit outside the
mowing area, protected from direct
sunlight, humidity and moisture – fasten
to a wall if necessary.
Correct operation of the power
supply unit is only ensured at an
ambient temperature between
0° C and 40° C.
0478 131 9935 C - EN
● Route all power cables outside the
mowing area, in particular out of reach
of the mowing blade, and fasten them to
the ground or accommodate in a cable
duct.
● Unreel power cables in the vicinity of
the docking station in order to avoid
interference with the wire signal.
● Connect the mains plug.
The red LED on the docking station
flashes rapidly as long as no
perimeter wire is connected.
(
13.1)
● After completing this installation
work, press the OK button.
With external docking station:
Define at least one starting point
outside the corridor to the docking
station after initial installation is
complete. Define the starting
frequency so that 0 of 10 mowing
operations (0/10) are started at the
docking station (starting point 0).
(
11.15)
Lift the robotic mower slightly by the
carrying handle (1) to relieve the weight on
the drive wheels. Push the machine,
resting on its front wheels, into the docking
station.
Then press the OK button on the
display.
If the battery is discharged, a
plug symbol appears instead
of the battery symbol at the
top right corner of the display after
docking and the battery is charged
while the perimeter wire is being
routed. (
15.7)
109
Publicité
