SRAM 0808 Instructions D'installation page 8

B B C u p M o u n t I n s t a l l a t I o n
The BB Cup Mount is only compatible with threaded bottom brackets. It does not work with frames that
have bearings pressed into the bottom bracket (BB30, PF30, etc.). Frames using threaded bottom bracket
adapters (ie. SRAM GXP30 BB Adapter) may use the BB Cup Mount if the mount is installed onto the
threaded drive side bottom bracket cup.
1. If necessary, remove the existing cranks and bottom bracket.
2. Slide the BB Cup Mount over the threads of the drive side bearing cup with the magnet facing away
from the frame.
3. Hold the magnet at the 9 o'clock position while the bottom bracket is tightened to the manufacturer's
recommended torque.
4. Confirm the magnet is within 2-8 mm (1/16"-3/8") of the sensor.
8
BB Cup Mount InstallatIon
2-8 mm
(1/16"-3/8")