SRAM 0808 Instructions D'installation page 10

a d h e s I v e p u t t y I n s t a l l a t I o n
The included adhesive putty will permanently attach the magnet to your frame. Other non-permanent
attachment options include: hot glue, some epoxies, electrical tape, or similar adhesives.
Installation Notes: Do not allow the magnet to contact the power meter. When properly installed, the
magnet should be in line with the cadence sensors and within 2-8 mm (1/16"-3/8") of the sensors.
Depending on your frame, you may need to stack magnets to achieve this distance.
1. Remove the existing cranks.
2. Use the included sandpaper to gently scuff the frame where the magnet will be mounted. The center
of the magnet should be positioned between 27.5 mm and 30 mm (1" - 1 1/8") from the center of the
bottom bracket.
3. Clean the frame with the included alcohol pad prior to attaching the magnet.
4. Knead both colors of adhesive putty with your fingers until you have one consistent color.
5. Place a 6 mm (1/4") diameter ball of putty on the back of the magnet, and then press the magnet onto
the frame.
6. Use a toothpick to carefully remove any excess putty before it dries. The putty will set up in about 10
minutes, and will cure in 1 hour.
7. Reinstall the cranks.
8. Confirm the magnet is within 2-8 mm (1/16"-3/8") of the sensor.
10
Adhesive Putty instAllAtion