SRAM 0808 Instructions D'installation page 12

p a I r I n g
Before pairing your power meter to a computer, make sure you are at least 10 meters (30 feet) from any
other ANT+™ device. This will keep you from accidentally pairing to another person's ANT+ device.
To pair the power meter with an ANT+ computer, first spin the crank backwards 2-3 times to wake the power
meter and begin broadcasting ANT+ messages. The power meter will shut off after about 10 minutes of
inactivity.
Follow the pairing instructions specific to your ANT+ computer.
g a r M I n ® e d g e ® 8 0 0
To pair the power meter:
Click the Power button → tap the Dumbbell icon
"Power meter Detected" will flash up on your screen when the units are paired.
g a r M I n e d g e 5 0 0
To pair the power meter:
menu → settings → bike settings → bike 1 → anT+Power → rescan
"Power meter Detected" will flash up on your screen when the units are paired.
g a r M I n F o r e r u n n e r ® 3 1 0 X t & 9 1 0 X t W at C h
Your watch must be in bike mode in order to pair and zero your power meter (press and hold the Mode
button).
To pair the power meter:
mode → bike settings → bike 1 → ant+Power → restart scan
"Power meter Detected" will appear on your screen when the units are paired.
Z e r o I n g
The power meter must be zeroed to compensate for environmental changes. The power meter can be
zeroed two ways: Auto Zero and Manual Zero.
When to perform the Zero procedure
For best results, you should perform the Manual Zero procedure before you start each ride. The Auto
Zero procedure can be performed instead of a Manual Zero or if your computer cannot send a "Calibrate"
command; if the temperature changes greatly during your ride; or if you feel that you are getting inaccurate
data.
12
Pairing
→ rescan