SRAM 0808 Instructions D'installation page 16

T r o U b l e s H o o T I n G
Performing a Self-Test can quickly diagnose problems with the Power Meter.
Perform a Self-Test by back-pedaling several times, and then observe the LED.
• No flash: Dead battery, or magnet not installed.
• 1 flash: Self check pass. Head unit paired.
• 2 flashes: Self check pass. No head unit paired.
• 3 flashes: Self check Fail. Reed switch Failure.
• 4 flashes: Self check Fail. Bad Strain Gauge.
Power Meter does not pair with the computer
• Check the battery. The battery must be installed correctly ("+" out) and have sufficient charge. Make
sure the battery contact is free of corrosion.
• Check the magnet position. Confirm the magnet is within 2-8 mm (1/16"-3/8") of the sensor. The magnet
should be installed according to the instructions on pages 8-10. Once the cadence sensors have been
activated, the power meter will begin transmitting messages and is ready to be paired.
• Make sure the proper pairing technique has been followed for your bike computer. The pairing process
will vary by manufacturer. Refer to your bike computer's instruction manual.
• If you are using a Garmin
when you are wearing the heart rate monitor/strap. Turn off the ANT+ HRM function if you are not using
a heart rate strap.
• Check with Quarq for the recommended firmware version for your Garmin computer. Follow the
instructions specific to your ANT+™ computer to check the installed firmware version.
g a r M I n e d g e ® 8 0 0
menu → settings → about edge
g a r M I n e d g e 5 0 0
menu → settings → about edge
To view the menu, you must press and hold the Menu button until the menu pops up.
g a r M I n F o r e r u n n e r ® 3 1 0 X t & 9 1 0 X t W at C h
mode → settings → about forerunner
16
TROUBLESHOOTING
bike computer with ANT+™ heart rate enabled, calibration will often be faster
®