Publicité
Les langues disponibles
Les langues disponibles
STEP 17
Installation of cable 2 (28) with cable pulley units.
1. Pull cable 2 (28) through the big hole of support 2 (7) and
connect the end of cable 2 (28) at cable pulley holder 2 (6)
by using screw M10x25 (109), washer 10//20 (118) and self
locking nut M10 (124) as showed in gure „C".
2. Put two cable roller unit as gure „A" shows together with
screw M10x45 (110), washer (118) and self locking nut (124),
insert the cable 2 (28) and install these units at holder of front
foot (1) in a way that the cable pulley can roll easy.
3. Put a cable roller unit as gure „A" shows together with
screw M10x45 (110), washer (118) and self locking nut (124),
insert the cable 2 (28) and connect this at twin cable pulley
holder (27) in a way that the cable pulley can roll easy.
4. Take cable 2 (28) and enlarge it with 8 links chain (53) and
two carbine hooks (55) and connect cable 2 (28) with cable
pulley holder 2 (6), which is pre-assembled at cable 1 (26).
(Note: To get a smooth sliding cable system, you may adjust
the cable system at 8 links chain (53) with carbine hooks (55)
through setting them into another position.)
5. Then put the screw caps for M10 (131) onto all M10 screw
heads and nuts.
STEP 18
Installation of weight casing (41) with weight casing
support (42) and bending plate (43).
1. Connect the weight casing support (42) and bending plate
(43) at appropriate position of weight casing (41) by using
screw M6x16 (100), washer 6//12 (116) and self locking nut
M 6 (126). Note, that the weight casing supports (42) and
bending plates (43) have to mount into the right position as
showed in Step 18 drawing.
STEP 19
Installation of weight casing (41) with supports (42+43) at
L-plate (32) and rear foot (2).
1. Put the weight casing (41) with pre-assembled weight
casing support (42) into the holes of rear foot (2). Get the end
of opposite weight casings supports (42) and bending plates
(43) together and screw them tightly by using screw M6x16
(100), washer 6//12 (116) and self locking nut M6 (126) as
showed in gure „A".
2. Put the L-plate (32) under the top cross beam (5) into
appropriate position and screw it tightly by using screw M8x65
(106), washer 8//16 (117) and self locking nut M8 (125) as
showed in gure „B".
3. Connect the upper bending plate connection additionally at
L-plate (32) by using screw M6x20 (135), washer 6//12 (116)
and self locking nut M6 (126).
4. Then put the screw cap for M8 (132) onto the M8 nut.
6
55
53
55
7
28
6
27
A
A
43
B
43
41
B
42
5
B
A
1
24
A
84
118
84
83
110
118
131
C
118
136
118
28
124
131
1
Cable 2
C
1980mm
43
B
A
43
A
126 116
116 100
42
A
106
B
117
126
116
116
32
125
117
132
A
126
116
116
GB
124
131
131
28
41
5
135
100
Publicité
