Christopeit Sport SP5000 Instructions De Montage Et D'utilisation page 21

STEP 10
Installation of seat frame (13) at leg curler support (12)
and standing plates (47) at front foot (1).
1. Slide the seat frame (13) into the appropriate holder of leg
curler holder (12) and secure it into desired position by using
the quick lock knob (74). (Note: to screw in the quick lock knob
(8), the treaded hole in the leg curler support (12) and one of
the holes in the seat frame (13) must be aligned. The setting
of the seat can be adjusted as desired later. For this, the quick
lock knob (8) must be loosened by only a few revolutions, the
cap of the lock must be pulled away and the seat adjusted.
Then secure the new setting by tightening the quick lock knob
(8).)
2. Place the standing plates (47) in front of the holder at front
foot (1) und screw them tightly by using screw M10x75 (113),
washer 10//20 (118) and self locking nut M10 (124).
3. Then put the screw caps for M10 (131) onto all M10 screw
heads and nuts.
STEP 11
Installation of leg curler (15) and arm curl pad (20) at leg
curler holder (12).
1. Put the leg curler (15) with pre-assembled steel bearings
1 (44) into the appropriate holder of leg curler holder (12) and
screw it tightly by using screw M10x90 (115), washer 10//20
(118) and self locking nut M10 (124), Attention, the leg curler
(15) should turn easy when it is assembled.
2. Slide the round pad holder (18) into the holder of leg curler
(15) in middle position and slide two red foam rubber rolls (64)
onto the ends of round pad holder (18).
3. Adjust the arm curl pad (20) on arm curl stand (16) so that
the threaded holes in the rear of arm curl pad (20) are align
with the arm curl stand (16) and screw it tightly by using screw
M8x20 (101), spring washer for M8 (123) and washer 8//16
(117).
4. The arm curl stand (16) with pre-assembled arm curl pad
(20) could be mounted in desired position at leg curler (15) and
secured by using the hand grip bolt 1 (69).
5. To secure the position of leg curler (15) please slide the
long safety bracket (52) through the aligned holes of leg curl
holder (12) and leg curler (15).
6. Then put the screw caps for M10 (131) onto all M10 screw
heads and nuts and the screw caps(132) for M8 onto all M8
screw heads and nuts.
131
101
132
12
118
115
131
52
21
13
12
124
74
118
1
47
118
113
117
123
20
16
124
118
131
44
69
18
15
GB
131
64