Christopeit Sport SP5000 Instructions De Montage Et D'utilisation page 18

GB
ASSEMBLY INSTRUCTIONS
Before beginning assembly, be sure to observe our rec-
ommendations and safety instructions. Some parts are
pre assembled.
STEP 1
Installation of front foot (1), rear foot (2) and guide bars
(10).
1. Put the ront oot (1) and rear oot (2) on an even oor in the
right way together. (Attention: According to assembly version
whether dips- and step-unit left or right, the rear foot (2) must
be mounted into appropriate position.)
10
2. Put the guide bars (10) (ends with holes) into the appro-
131
priate position of rear foot (2) and screw front foot (1), rear foot
134
(2) and guide bars (10) with screw M10x70 (112), Adjusting
plate (134), washer 10//20 (118) and self locking nut M10 (124) 124
118
tightly. Ensure that the screws are put through the holes of
guide bars so that they are blocked in bottom position.
2
118
1
3. Then put the screw caps for M10 (131) onto all M10 screw
112
heads and nuts.
131
10
STEP 2
Installation of weight plates (66+67) at guide bars (10).
66
1. Slide the weight supports (23) onto the guide bars (10).
40
2. Then put the rubber buer (78) onto the guide bars (10).
(If you bought the option weight set Art.-No. 9388 you have
to put on the 2 weights of option set instead of the weight
supports, But rstly you have to slide onto the guide bars (10)
the rubber buer (78)).
67
3. Place the 11 weights (67) onto the guide bars (10) as you
can see on step drawing 2.
78 51
4. Put the weight disc bar (40) into the weight plates (67) and
23
put at least the smaller rst weight (66) on.
5. To adjust the loaded weights use the weight selector bar
2
(51) and put it into the weight disc bar (40) in desired position.
1
STEP 3
Installation of supports 1+2 (4+7) at front foot and rear
foot (1+2).
1. Put the support 1 (4) into the appropriate position of rear
oot (2) and tighten it rmly by using screw M10x70 (112),
washer 10//20 (118) and self locking nut M10 (124).
2. Put the support 2 (7) into appropriate position of front
4 7
oot (1) and tighten it rmly by using screws M10x70 (112),
washers 10//20 (118) and self locking nut M10 (124).
3. Then put the screw caps for M10 (131) onto all M10 screw
131
heads and nuts.
124 131
118
124
118
118
112
118
131 112
18