Christopeit Sport SP5000 Instructions De Montage Et D'utilisation page 19

STEP 4
Installation of tabular guide holder (3) and top cross
beam (5) at supports 1+2 (4+7).
1. Place the tabular guide holder (3) onto the ends of guide
bars (10) and support 1 (4).
2. Screw the tabular guide holder (3) at guide bars (10) tightly
by using screw M10x20 (108), spring washers for M10 (122)
and washers 10//20 (118). Screw two screws (108) with the
washers (118) to decorate the thread holes of the support 1
(3).
3. Connect the end of support 1 (4) with tabular guide holder
(3) und screw them together by using screw M10x70 (112),
washer 10//20 (118) and self locking nut M10 (124).
4. Put the top cross beam (5) in appropriate position onto the
support 2 (7) and tighten it rmly by using screw 10x20 (108),
spring washer for M10 (122) and washers 10//20 (118) at
support 2 (7).
5. Screw tightly the top cross beam (5) at tabular guide holder
(3) by using screw M 10x20 (108), spring washer for M10 (122)
and washers10//20 (118).
6. Then put the screw caps for M10 (131) onto all M10 screw
heads and nuts.
STEP 5
Installation of bench press support (38) and cable pulley
holder 1 (8) at support 2 (7).
1. Place the bench press support (38) in appropriate position
at support 2 (7) and screw these parts together by using screw
M10 x 65 (111), washers 10//20 (118) and self locking nut M10
(124).
2. Put the cable pulley holder 1 (8) into the holder at sup-
port 2 (7) and screw them together by using screw M10x80
(114), washer 10//20 (118) and self locking nut M10 (124).
Attention! Thecablepulleyholder1(8)shouldturneasywhenitis
assembled.
3. Then put the screw caps for M10 (131) onto all M10 screw
heads and nuts.
STEP 6
Installation o buttery arm holder (9) at top cross beam
(5).
1. Place the buttery arm holder (9) in appropriate position at
top cross beam (5), so that the holes with steel bearings are
align and slide the axle 2 (39) through the buttery arm holder
(9) and top cross beam (5).
2. Secure the axle 2 (39) by using screw M8x15 (99), spring
washers for M8 (123) and washers 8//28 (121) on both sides.
3. For buttery exercising you have to secure the buttery
arm holder (9) with handgrip bolt 2 (70) and washer 10//38
(120) at bench press support (38).
131
108
118
124
118
118
112
4
10
131
124
118
124
118
8
7
118
114
131
121
123
99
19
108
122
118
3
5
118
122
131
108
118
122
131
108
7
131
118
111
131
38
38
5
123
121
39
9
120
GB
99
70