Christopeit Sport SP5000 Instructions De Montage Et D'utilisation page 20

STEP 7
Installation o buttery arms (11+14) at buttery arm
holder (9) and foam rubber roll (63) and hand grips (19).
1. Put the buttery shats (45) into the holder o buttery arm
let and right (11+14) and place the buttery arms (11+14) in
right position into the appropriate holder o buttery holder (9).
2. Screw the buttery arms (11+14) at buttery arm holder (9)
tightly by using screw M10x20 (108), spring washer for M10
(122) and washer 10//20 (118) on bottom and top side.
3. Slide the foam rubber roll (63) with help of a little bit soap
water onto the buttery arms (11+14).
4. Place the hand grips (19) into appropriate holder of
buttery arm let and right (11+14) and screw them tightly
by using screw M8x30 (102), washer 8//16 (117) and spring
washer for M8 (123).
5. For bench press exercising secure the buttery arms let
and right (11+14) with locking pins (49) at buttery holder (9)
and screw out the handgrip bolt 2 (70) of bench press support
(9).
6. For buttery exercising secure the buttery arm holder (9)
with hand grip bolt 2 (70) at bench press support (38) und take
out the locking pins (49) rom buttery arms (11+14).
7. Then put the screw caps for M10 (131) onto all M10 screw
heads and nuts and the screw caps(132) for M8 onto all M8
screw heads and nuts.
STEP 8
Installation of the back pad (60) and leg curler holder (12)
at support 2 (7).
1. Adjust the back pad (60) on support 2 (15) so that the
threaded holes in the rear of the back pad (60) are align with
the holes in support 2 (7) and screw it tightly by using screw
M8 x 70 (107), spring washer for M8 (123) and washer 8//16
(117).
2. Then mount the head pad (65) in the same way as the back
pad (60).
3. Place the leg curler holder (12) in appropriate position at
support 2 (7), so that the holes are align and screw it tightly
by using screw M10x70 (112), adjusting plate (48), washers
10//20 (118) and self locking nut M10 (124).
4. Then put the screw caps for M10 (131) onto all M10 screw
heads and nuts and the screw caps(132) for M8 onto all M8
screw heads and nuts.
STEP 9
Installation of seat pad (17) and round pad holder (18) at
seat support frame (13).
1. Adjust the seat pad (17) on seat support frame (13) so that
the threaded holes in the rear of seat pad (17) are align with
the seat support frame (13) and screw it tightly by using screw
M8x45 (104), spring washer for M8 (123) and washer 8//16
(117).
2. Slide the round pad holder (18) into the seat support frame
(13) in middle position.
3. Slide two black foam rubber roll (64) onto the ends of round
pad holder (18).
131
108
122
118
45
11
118
122
108
132 107
123
117
7
131
112
118
1
13
20
14
49
70 63
9
117
131
65
60
48
118 124
131
12
17
18
117
123
104
GB
19
132
123
102
64