Fluke 3563 Guide D'introduction page 22

Commission Sensors
Assign sensors to asset test points
1. Tap Assign on the Sensors screen. The asset hierarchy configured in
eMaint condition monitoring appears in the Assign Asset screen.
2. Assign selected sensor to desired asset test point.
3. Tap Save to complete the action.
NOTE: If no asset hierarchy has been configured within the
eMaint condition monitoring, then no asset hierarchy will appear when Assign is
selected.
On completion, the assigned sensor appears on the sensor list with a breadcrumb
showing the test point within the hierarchy (e.g. Building 1>Wing A>Asset1>Driver
Component>Motor>Test Point1).
To change or unassign a test point, tap the pencil icon (next to the breadcrumb). This
returns user to the individual asset screen. Select None to unassign the test point.