Fluke 3563 Guide D'introduction page 19

Getting started with Analysis Vibration Sensor System
On connecting a gateway to the Ethernet LAN, DHCP automatically assigns an address
to the gateway.
Tap Update To Gateway to send network information to the gateway.
The Home screen shows whether the gateway was commissioned or not.
Commissioning sensors
With at least one gateway commissioned, the user may now commission sensors.
1. Make sure sensors are correctly powered. If battery terminals were protected
during transport ensure that the insulation is removed. Refer to page 39 for
details on powering the sensor.
2. From the Home screen, tap Add New in the Sensors frame to open the Add
Sensors screen.
16