Fluke 3563 Guide D'introduction page 12

4. Use the Components editor to define the asset components.
For details, refer to the online help.
5. In the Test Points editor, click
3563 Analysis Vibration Sensor. Define the required test points:
y Test point name – edit name
y Position on the machine – define test point position
y Orientation – define sensor orientation at the test point
For details, refer to the online help.
6. Use the Tasks and Alarms editor to configure the vibration trends to be measured
and the alarm limits to be set. There is the possibility to apply recommended
alarm limits that are based on verified ISO standards and experience.
For details, refer to the online help.
7. Use Device Settings editor to schedule measurement. This can be at regular
intervals or only when the machine is in operation or create a measure schedule.
For details, refer to the online help.
at the respective component, then select the
9
Setting up Assets