Publicité
Les langues disponibles
Les langues disponibles
NETWORK MENU
For example, if you set it up like this:
• Wired WAN Ratio:
• Mobile WAN Ratio:
Then about 60 % (3/5) of traffic would go through the Wired WAN interface and about 40 % (2/5) would go
through Mobile WAN. In this case if you played 100 different videos on the Internet, about 60 would be down-
loaded through Wired WAN and the other 40 would be downloaded via Mobile WAN.
Rules
A Load Balancing/Failover Rule is a set of conditions that define some type of network traffic. The traffic that
matches the conditions set in the rule is handled in accordance to the specified Policy.
There is one default rule present on the device. You can add more rules with the 'Add' button or you can custo-
mize the existing rule by clicking the 'Edit' button next to it:
Field
Protocol
Source address
Destination address
Sticky
Sticky timeout
Policy assigned
Policies
A Policy dictates what the the device should do when some network traffic matches the condition defined in a
Failover/Load Balancing rule. There are two policies by default, one for Load Balancing, the other for Failover. You
may create custom policies that use different interfaces for Failover/Load Balancing scenarios.
ALD-16690
3
2
Value
Description
All | tcp | udp | icmp |
Protocol to match this rule.
esp;
Default: all
Ip/netmask;
Source IP addresses to match this rule.
Default: none
Ip/netmask;
Destination IP addresses to match this rule.
Default: 0.0.0.0/0
Off | on;
If turned on, traffic from the same source IP address
Default: off
that previously matched this rule within the sticky
timeout period will use the same WAN interface.
Integer [1..1000000];
Timeout in seconds.
Default: 600
default (Load
Selects the policy to apply to traffic that matches the
Balancing)
conditions of this rule. You can create custom Load
Balancing/Failover policies in the section below.
210
Publicité
