ALDEN I-NET 151 Guide D'installation page 149

Warnings
No part of this guide may be reproduced without the written consent of ALDEN.
ALDEN draws particular attention to the risks incurred in the event of improper assembly.
ALDEN cannot be held liable for installation that does not comply with the rules of the trade and in particular if the
installation is carried out by a non-professional.
The dealer is deemed to be familiar with the rules of the trade and to comply with them. He shall in particular
respect the rules concerning the choice of location, electrical connection, gluing and screwing. He undertakes,
when selling and installing an ALDEN product, to inform his customer of the instructions for use and, if applicable,
the installation instructions, and shall provide him with the necessary documents. He shall draw the customer's
attention to all safety aspects. He shall inform the customer that the product sold must not be diverted from its
intended use. In addition, he shall draw the customer's attention, where applicable, to the obligation to comply
with the laws in force in the country or countries of use.
Any work carried out on the product without prior agreement from ALDEN shall render the warranty null and void.
Neither the seller nor the manufacturer can be held responsible in any way for changes in emission modes or
power levels. Events unknown to the seller and the manufacturer may not give rise to a request for exchange,
reimbursement or compensation of any kind. The reception areas are given as an indication.
ALDEN declines all responsibility of any nature whatsoever, in particular for any accident or incident in the event
of non-observance of the instructions given, both in terms of installation and use.
The opening of the various elements is strictly forbidden. No warranty claims will be possible in this case.
For any intervention on the electrical circuit, replacement or connection of the battery, the fuses of the power
supply cables of the satellite equipment must be removed. If the vehicle is equipped with a solar panel, also
remove the fuse from the charge controller.
It is imperative that a separate, fused 3 Amp supply is drawn directly from the cell battery to power the router.
It is imperative to protect the cable ends with tape during installation.
Only use original spare parts and accessories or parts recommended by a specialist dealer, otherwise the warranty
will be void. Any work on the appliance must be carried out by qualified technicians.
Do not open the cover of the appliance, as this may cause electric shocks and void the warranty. Only qualified
personnel should service and maintain the appliance.
When connecting the cables, make sure that the appliance is unplugged. Wait a few seconds after switching off the
unit before moving it or disconnecting the connected cables.
If the unit does not work properly after you have strictly followed all the instructions in this manual, contact your
dealer.
This device meets government requirements for exposure to radio waves. This device is designed and manufactured
not to exceed the emission limits for exposure to radio frequency (RF) energy set by authorized agencies. To
ensure compliance with RF exposure guidelines, the device should be operated with a minimum distance of 20 cm
from a person's body. Failure to do so may result in RF exposure exceeding the limits of the relevant guidelines.
External antennas used with the I-NET 151 must be installed to provide a separation distance of at least 20 cm
from all persons and must not be co-located or used in conjunction with any other antenna or transmitter.
Any external antenna gain must comply with the RF exposure and maximum radiated output power limits of the
applicable rule section.
• The fact of proceeding with the installation implies the acceptance of the rules stated. •
ALD-16690 149