Publicité
Les langues disponibles
Les langues disponibles
NETWORK MENU
Firewall Settings
The Firewall Settings section is used to specify to which firewall zone if any this interface belongs. Assigning an
interface to a zone may provide easier configuration of firewall rules. For example, instead of configuring separate
rules for each WAN interface, you can add all WAN interfaces into a single firewall zone and make the rule apply
to that zone instead.
More firewall zone settings can be configured from the Network → Firewall → General Settings → Zones section.
Field
Create / Assign firewall-
zone
DHCP Server
A DHCP (Dynamic Host Configuration Protocol) server is a service that can automatically configure the TCP/IP
settings of any device that requests such a service. If you connect a device that has been configured to obtain an
IP address automatically, the DHCP server will lease out an IP address from the available IP pool and the device will
be able to communicate within the private network.
To make the DHCP Server section visible, set interface protocol to Static.
DHCP Server: General Setup
The General Setup section is used to set up the main operating parameters of the DHCP server.
Field
Enable DHCP
ALD-16690
Value
firewall zone; default:
none
Value
Description
Enable | Disable |
Turns the DHCP server on or off or enables DHCP relay*.
DHCP Relay*;
If DHCP Relay* is selected, you will be prompted to enter an
Default: Enable
IP address of another DHCP server in your LAN. In this case,
whenever a new machine connects to this device, it will redirect
any DHCP requests to the specified DHCP Server.
Description
Assigns this interface to the specified firewall zone.
193
Publicité
