Motorola MTX1550 Guide De L'utilisateur page 40

20L01-A_PR_UG_MTX4500.book Page 38 Friday, April 13, 2007 2:47 PM
Scan Modes
When programming the scan list, each member can be given one of several scan modes. The following
table lists the scan mode cycle activated by subsequent presses of the select key.
Initial Scan Mode
of Member
Priority 2*
Priority 1*
Non-Scan
Member
Scan Member
* Priority options are only available if enabled.
Note: There can only be ONE Priority 1 member
38
English
Number of Times the Select Key is Pressed
1
Priority 1*
Non-Scan
Member
Scan Member
Priority 2*
and ONE Priority 2 member in a scan list.
Thus, if there is already a Priority 1 member
in the scan list, changing another member's
mode to Priority 1, would automatically
cause the previous member's mode to be
changed to a Scan Member.
2 3
Non-Scan
Scan Member
Member
Scan Member Priority 2*
Priority 2* Priority 1*
Non-Scan
Priority 1*
Member
This same behavior is also seen when
programming the Priority 2 member.
4
Priority 2*
Priority 1*
Non-Scan
Member
Scan Member