Motorola MTX1550 Guide De L'utilisateur page 39

20L01-A_PR_UG_MTX4500.book Page 37 Friday, April 13, 2007 2:47 PM
Note: The programming-mode annunciator, K, is
displayed while list view mode is active.
• The scan status annunciator, G, appears,
indicating that a scan list is being viewed.
• The dot of the priority scan annunciator,
H, blinks if the current displayed
member of the scan list is a priority 1
mode, and is solid the current displayed
member of the scan list is a priority 2
mode.
Programming a Scan List (For Keypad
Radios Only)
The program scan list feature allows you to program
the members of the scan list associated with the
currently selected mode.
To program a scan list
1 Press / until
PROG is displayed.
2 Press l (the
softkey below
PROG).
3 Press l (the
softkey below
SCAN). The display
shows the current
mode selected.
4
5
6
7
8
Note: The programming-mode annunciator, K,
PROG
SCAN PHON CALL
For example
FIRE DEPT
Use the mode selector knob to select the
required talkgroup zone.
Press , or / to select the required
zone. If the scan status annunciator G is
displayed, the mode is part of the scan list.
Press the select key to change the scan
mode (See Scan Modes on page 38).
After making all the changes, select the
required operating mode.
Press the HOME key, or the PTT switch, or
turn the mode selector knob to commit all the
changes made.
blinks while program mode is active.
• The scan status annunciator, G, appears,
indicating that a scan list is being viewed.
• The dot of the priority scan annunciator,
H, blinks if the current displayed
member of the scan list is a priority 1
mode, and is solid the current displayed
member of the scan list is a priority 2
mode.
37
Englis