Motorola MTX1550 Guide De L'utilisateur page 29

20L01-A_PR_UG_MTX4500.book Page 27 Friday, April 13, 2007 2:47 PM
To Enter a Number from a Location in the Call List
4a Press either , or / to enter the call
list.
4b Enter the first digit of the location number. If
there are fewer than 10 members in the list,
go directly to Step 4e.
4c If there are 10 or more members in the list,
the display shows "ID LOC#X_" (where X is
the first digit). The cursor blinks to show the
location of the second digit.
4d Enter the second digit of the location number.
4e The radio goes to that
position in the list. The
display alternates
between showing the
member's name and ID
number.
Note: The last member of the list is also the "last ID
transmitted or received" at position "00" on
the list.
• If you enter a location number that does
not exist (for example, "15"), the display
shows "INVALID ENTRY", and the radio
sounds an invalid-keypress tone and
returns to Step 4b of this procedure.
Sending the Radio ID Number
5 Press the PTT switch to transmit the ID
6 If the radio you are calling is on the air, you will
7 If the party you are
Alternates between
CK TANG
and
8 If the party you are calling answers the call,
ID: 784116
Note: If the radio you are calling is not in service,
number.
hear a telephone-type ringing for 20 seconds,
or until the called radio answers the call.
calling does not answer
the call within twenty
NO ANSWER
seconds, the telephone
ringing stops and an
alert tone sounds.
At this point you can either send a Call Alert™
page, or go to Step 10 to hang up.
you will hear his/her voice.
you will not hear the ringing and the display
will show "NO ACK". Go to Step 10 to hang
up.
• If your radio is configured for Private Call II,
you will not hear the telephone type
ringing. Instead you are able to proceed to
talk to the Called party.
27
Englis