Motorola WAVE Mobile TLK 150 Mode D'emploi page 33

Figure 20: Emergency Switch Wiring Diagram
SPST NORMALLY OPEN
EMERGENCY SWITCH
3.2
Mounting External Speaker
The external speaker kit includes a trunnion bracket that allows the speaker to be mounted in various
ways.
Prerequisites:
CAUTION: Do not ground the radio speaker leads. This system has a floating speaker output
(dc voltage on both leads); grounding or shorting both leads damage the audio circuit.
When and where to use: With the trunnion bracket, the external speaker can be mounted
permanently on the dashboard or in accessible firewall areas. The trunnion allows the external speaker
to tilt for best operation. Mount the external speaker out of the way so that it will not be kicked or
knocked around by the vehicle occupants.
Procedure:
1 Use the external speaker mounting bracket as a template to mark the mounting hole locations.
2 Use the self-drilling screws provided to fasten the trunnion.
3 Attach the external speaker and fasten to the trunnion with two wing screws.
4 Route the speaker wires under the carpet or floor covering, or behind the kick panels. Be sure
that the wires are out of the way and will not be snagged and broken by the occupants of the
vehicle.
20 2 4 6 8 10
19 1 3 5 7 9
Chapter 3 : Accessories Installation
NOTE 1
ACCESSORY
CONNECTOR
12 14 16 18
11 13 15 17
MN007262A01-AE
PIN 9
PIN 7
33