Motorola WAVE Mobile TLK 150 Mode D'emploi page 19

2 Using the trunnion mounting bracket as a template, mark the positions of the holes on the
mounting surface. Use the innermost four holes for a curved mounting surface such as the
transmission hump, and the four outmost holes for a flat surface such as under the dash.
3 Center punch the spots you have marked and realign the trunnion in position.
4 Secure the trunnion mounting bracket with the four self-drilling screws provided. The number of
screws used will depend on how the radio is mounted.
5 Position the radio to align the trunnion with the trunnion mounting features on the radio. Secure
the radio with the two wing screws and lock washers (position the flat side of the washer to the
thumbscrew and the washer sharp side to the trunnion) provided.
Figure 9: Transmission Hump Trunnion Mounting
1
Label
1
2
3
4
5
6
7
Chapter 2 : Installation Details for Standard Configurations
2
3
Description
Wing Screw
Lock Washer
Trunnion
Tabs
Wing Screw
Lock Washer
Threaded Hole for Wing Screw
7
6
4
5
MN007262A01-AE
19