Renson Camargue Skye Notice De Montage page 189

PROBLEM
The end sensors are detected at an unexpected location.
The start sensors are detected at an unexpected location.
No speed pulses detected on one of the slide motors or tilt motors.
Malfunction of start sensor.
No current supply to the motor is detected.
Incorrect motor direction detected.
Error signal from the motor driver detected.
This can be caused by overheating, overload or overvoltage.
The LED safety circuit is enabled.
SOLUTION
1. Perform calibration.
2. If the error persists after calibration, unplug the plug from the socket and plug it in again after 30 seconds.
3. If the error also persists in cold temperatures, check the wiring or replace the motherboard.
1. Perform calibration.
2. If the error persists after calibration, unplug the plug from the socket and plug it in again after 30 seconds.
3. If the error also persists in cold temperatures, check the wiring or replace the motherboard.
1. Perform calibration.
2. Check the wiring.
3. Replace the defective motors.
4. Unplug the plug from the socket and plug it in again after 30 seconds.
5. If the error persists after restarting, check the wiring or replace the motherboard.
1. Unplug the plug from the socket and plug it in again after 30 seconds.
2. If the error persists after restarting, check the wiring or replace the motherboard.
1. Replace the current supply to the motor.
2. If the error persists after restarting, check the wiring or replace the motherboard of the device.
1. Check the wiring and check the motor.
2. Unplug the plug from the socket and plug it in again after 30 seconds.
3. If the error persists after restarting, replace the motherboard of the device.
1. Try again after 60 seconds.
2. Perform a calibration.
3. Unplug the plug from the socket and plug it in again after 30 seconds.
4. If the error persists after restarting, replace the motherboard of the device.
1. Try again after 60 seconds.
2. Unplug the plug from the socket and plug it in again after 30 seconds.
3. If the error persists after restarting, replace the motherboard of the device.
Camargue Skye
®
189