Publicité
Les langues disponibles
Les langues disponibles
2.5 Replacing various parts
WARNING!
Parts replacement and adjustment work is classed as non-routine maintenance,
meaning it must be carried out by an authorized installer.
Before starting any repair or maintenance work you must turn off the appliance with
the master switch so that it is not powered.
Also close water supply cocks.
Door's disassembly
The hinges
(A)
have been equipped with two moveable levers
sections
(C),
and hold the door in place when it is completely open.
Pull it away from th eoven by completing the two movements illustrated
operations hold the door by the sides at the bottom near the hinges.
To replace the door put the hinges back into their appropriate positions. Before closing the door do not
forget to remove the two levers
Oven lamp
Unscrew the protective cap
the lamp. Immediately after the bulb has been changed, remount the protection cover
Heating element
The heating element is removed by unscrewing it from the inside of the cooking chamber. The electrical
connections are accessible from behind once the back panel has been removed.
Oven fan
Once the back has been removed, take off the side racks and the fan protection from inside the oven.
Unscrew the central nut, eventually the lateral screw on the motor's rotor too, to free the fan. Pull it out
and then unscrew the screws holding the motor flange.
Door seal
By hand, take out the seal from its position and replace it with a new one without tool.
A
Figure 5
(B)
which were used to hook the two hinges.
(A - Fig. 6)
which sticks out of the inside of the oven to provide access to
C
B
(B)
These levers hook on to the hinge
A
21
(Fig. 5),
to complete these
(A).
Figure 6
GB
Publicité
