Setting The Alarm Duration - Sygonix SY-4599778 Notice D'emploi

Example:
• Press the
• Enter one of the following values:
= Toggle mode, relay output changes the operating mode
= Relay output is activated for 1 second
-
seconds (example:
• Press the
briefly turn green and then flash red (programming mode).
• To exit programming mode, press the
indicator will switch to constant red to indicate that the code
lock is in standby mode.
e) Setting the alarm duration
The alarm duration (for the security function and sabotage alarm)
can be set (from 1 to 3 minutes, default setting = 1 minute). To
configure the alarm and alarm duration, proceed as follows:
• The code lock must be in standby mode and the LED
indicator (2) must be red.
• Enable programming mode (see section 10 "Programming",
paragraph "b) Enabling/exiting programming mode") The
LED indicator (2) will then flash red.
Example:
key. The LED indicator will turn green.
= Output is activated for a duration of 2 to 99
key to confirm your entry. The LED indicator will
seconds).
key. The LED
47