Sygonix SY-4599778 Notice D'emploi page 26

Instead of simply deleting a user ID with the
corresponding transponder/PIN code, all data stored
in the code lock would have to be deleted for security
reasons in order to prevent unauthorised access.
We therefore recommend that you assign a user ID for
each authorised person and enter all data (employee
name, user ID, access mode: by transponder or user
PIN code, etc.) in a list.
First option: Adding a user transponder without a specific
user ID (user ID is assigned automatically)
The code lock will automatically assign the next available user
ID. However, it will not be possible to determine which ID was
assigned.
• The code lock must be in standby mode and the LED
indicator (2) must be red.
• Enable programming mode (see section 10 "Programming",
paragraph "b) Enabling/exiting programming mode"). The
LED indicator (2) will then flash red.
Example:
• Press the
code lock is now in add transponder mode.
• Hold a user transponder (1) over the keypad. The code lock
will beep when the user transponder has been detected. The
LED indicator will briefly flash green.
• Remove the user transponder from the keypad.
26
key. The LED indicator (2) will turn yellow. The