•
The LED indicator (2) will then turn yellow again.
•
The new user transponder will be associated with the
automatically assigned user ID.
A previously added transponder cannot be assigned
again to another user ID.
•
You can now add another user transponder. The next user ID
will be automatically assigned. Hold the next transponder and
proceed as described above.
•
To end the adding process and exit programming mode,
press the
The code lock is now in standby mode.
Second option: Adding a user transponder with a specific
user ID (manual assignment of user ID):
Enter a user ID. The user ID must consist of the numbers 0 to
989. Note down the user ID. It can be assigned to a user at any
time. To add a user transponder with a manually assigned user
ID, proceed as follows:
•
The code lock must be in standby mode and the LED
indicator (2) must be red.
•
Enable programming mode (see section 10 "Programming",
paragraph "b) Enabling/exiting programming mode"). The
LED indicator (2) will then flash red.
Example:
•
Press the
code lock is now in add transponder mode.
key. The LED indicator (2) will stay constant red.
key. The LED indicator (2) will turn yellow. The
27