Sygonix SY-4599778 Notice D'emploi page 43

A guest transponder that has already been added/
saved cannot be added again. In this case, the code
lock emits 3 short beeps and the LED indicator (2)
flashes red before turning yellow again.
The same applies if you enter a guest/user ID which is
already assigned to a guest transponder.
• You can now add other guest transponders up to the
maximum possible number. Start by entering the number of
uses and follow the steps above.
• To end the adding process and exit programming mode,
press the
red to indicate that the code lock is in standby mode.
Deleting guest transponders via the guest ID:
• The code lock must be in standby mode and the LED
indicator (2) must be red.
• Enable programming mode (see section 10 "Programming",
paragraph "b) Enabling/exiting programming mode") The
LED indicator (2) will then flash red.
Example:
• Press the
turn yellow. The code lock is now in delete mode.
• To delete a guest user, enter the guest ID that you want to
delete and complete your entry with the
Example:
key. The LED indicator (2) will switch to constant
key on the keypad. The LED indicator (2) will
key.
43