Sygonix SY-4599778 Notice D'emploi page 33

• To end the programming process and exit programming
mode, press the
constant red to indicate that the code lock is in standby mode.
Second option: Enter a user PIN code with a specific user
ID (manual)
The code lock will automatically associate the manually entered
user ID with the entered user PIN code.
• The code lock must be in standby mode and the LED
indicator (2) must be red.
• Enable programming mode (see section 10 "Programming",
paragraph "b) Enabling/exiting programming mode"). The
LED indicator (2) will then flash red.
Example:
• Press the
code lock is now in add transponder mode.
• Enter a user ID (a number from
Press the
• Enter a user PIN code and confirm your entry with the
key. The code lock will emit a beep. The LED indicator (2) will
briefly turn green, and then yellow again.
The user PIN code can be four to six digits and consist
of the numbers 0001 to 999999. 1234 cannot be
selected, as this code is reserved.
• The new user PIN code will be associated with the manually
assigned user ID.
key. The LED indicator (2) will switch to
key. The LED indicator (2) will turn yellow. The
key to confirm the user ID.
to ).
33