Sygonix SY-4599778 Notice D'emploi page 28

• Enter a user ID (a number from
• Press the
will briefly turn green, and then yellow again.
• Hold a user transponder over the keypad (1). The code lock
will beep when the user transponder has been detected. The
LED indicator will briefly flash green.
• Remove the user transponder from the keypad.
• The LED indicator (2) will then turn yellow again.
• The new transponder will be associated with the manually
assigned user ID.
A previously added transponder cannot be assigned
again to another user ID.
If a user ID was selected which is already saved to a
user transponder, the code lock will emit 3 short beeps
and the LED indicator (2) will flash red before switching
back to yellow. If this occurs, repeat the adding process
again.
• You can now add another user transponder. To add another
transponder, repeat the above process.
• Press the
code lock is now in add transponder mode.
• Enter a user ID (a number from
• Press the
will briefly turn green, and then yellow again.
• Hold the next transponder in front of the device and proceed
as described above.
28
key to confirm the user ID. The LED indicator (2)
key. The LED indicator (2) will turn yellow. The
key to confirm the user ID. The LED indicator (2)
to ).
to ).