•
Enable programming mode (see section 10 "Programming",
paragraph ""b) Enabling/exiting programming mode") The
LED indicator will then flash red.
Example:
•
Press the
lock is now in delete mode.
•
Enter
•
Press the
briefly turn green, and then yellow again.
•
All user data (user PIN codes and transponders) will be
deleted and the master code will be reset.
•
To end the deletion process and exit programming mode,
press the
red to indicate that the code lock is in standby mode.
b) Adding guest users:
Assigning guest PIN codes with a user ID
•
The code lock must be in standby mode and the LED
indicator (2) must be red.
•
Enable programming mode (see section 10 "Programming",
paragraph ""b) Enabling/exiting programming mode") The
LED indicator (2) will then flash red.
Example:
•
Press the
code lock is now in add transponder mode.
40
key. The LED indicator will turn yellow. The code
:
key to confirm your entry. The LED indicator will
key. The LED indicator will switch to constant
key. The LED indicator (2) will turn yellow. The