Sygonix SY-4599778 Notice D'emploi page 37

• Press the
indicator (2) will stay constant red. The code lock is now in
standby mode.
The following steps can be performed without switching
to programming mode:
• Press the
• Hold a user transponder over the keypad (1). The code lock
will beep when the user transponder has been detected. The
LED indicator will briefly flash green.
• Enter the link code
• Press the
• Enter the user PIN code that you want to reprogram/change
and confirm your entry with the
code again and confirm your entry with the
• The transponder and user PIN code are now associated with
one another and must be used together in order to activate
the relay.
Changing the user PIN code of a user ID
This operation allows a transponder user to change their own
user PIN code. Users can change their own user PIN codes
without switching to programming mode.
• Press the
• Hold the transponder associated with the user PIN that you
want to change over the keypad (1). The code lock will beep
when the user transponder has been detected. The LED
indicator will briefly flash green.
key to exit programming mode. The LED
key.
key to confirm your entry.
key.
.
key. Enter the user PIN
key.
37