Sygonix SY-4599778 Notice D'emploi page 29

• To end the adding process and exit programming mode,
press the
The code lock is now in standby mode.
Deleting a user transponder:
• The code lock must be in standby mode and the LED
indicator (2) must be red.
• Enable programming mode (see section 10 "Programming",
paragraph "b) Enabling/exiting programming mode"). The
LED indicator (2) will then flash red.
Example:
• Press the
turn yellow. The code lock is now in delete mode.
• To delete a user transponder, hold it in front of the keypad
on the code lock.
• When the transponder has been detected, the code lock will
beep and the LED indicator (2) will briefly turn green. The
LED indicator (2) will then turn yellow again.
• The user transponder is now deleted. If the transponder
cannot be found in the code lock memory, the code lock will
emit 3 short beeps and the LED indicator (2) will flash red
before switching back to yellow.
• You can now delete another user transponder. Simply hold it
in front of the code lock as described above.
• To end the deletion process and exit programming mode,
press the
The code lock is now in standby mode.
key. The LED indicator (2) will stay constant red.
key on the code lock. The LED indicator (2) will
key. The LED indicator (2) will stay constant red.
29