Sygonix SY-4599778 Notice D'emploi page 30

Deleting a user transponder using the user ID:
• The code lock must be in standby mode and the LED
indicator (2) must be red.
• Enable programming mode (see section 10 "Programming",
paragraph "b) Enabling/exiting programming mode"). The
LED indicator (2) will then flash red.
Example:
• Press the
turn yellow. The code lock is now in delete mode.
• Enter the user ID that you want to delete (a number from
to
Example:
permissions will be deleted)
• When the transponder has been detected, the code lock will
beep and the LED indicator (2) will briefly turn green. The
LED indicator (2) will then turn yellow again. The user ID has
now been deleted.
If the user ID cannot be found in the code lock memory,
the code lock will emit 3 short beeps and the LED
indicator (2) will flash red before switching back to
yellow.
• You can now delete other user IDs by entering the
corresponding numbers.
• To end the deletion process and exit programming mode,
press the
The code lock is now in standby mode.
30
key on the keypad. The LED indicator (2) will
) and complete your entry with the
: (User ID 12 and all corresponding
key. The LED indicator (2) will stay constant red.
key.