Sygonix SY-4599778 Notice D'emploi page 21

Entering programming mode:
• The LED indicator (2) on the top of the code lock must be red.
The code lock is now in standby mode.
• Press the
command/key press, the LED indicator (2) on the code lock
will flash red and you will hear a confirmation tone. (After
5 seconds without any additional entry, the code lock will
automatically revert to standby mode. You will hear three
beeps and the LED indicator (2) will turn red again.)
• Enter the master code ("123456: by default):
• Press the
The master code "123456" is a default factory setting
and must be changed as described in section 10
"Programming", "c) Changing the master code" before
the code lock is placed into regular use.
• The code lock will emit a beep and the LED indicator (2) will
start to flash red. Programming mode is now enabled.
Exiting programming mode:
Programming mode exits automatically after 30
seconds if no programming commands (key presses)
are made. The code lock will then return to standby
mode (the LED indicator (2) will turn red).
key. If the code lock has recognized the
key to confirm your entry.
21