Sygonix SY-4599778 Notice D'emploi page 41

• Enter the number of uses for the guest PIN code and
complete your entry with the
The number of uses for a guest can be set from 1 to 10
(0=10 uses).
• Enter a user ID (a number from
• Now enter a guest PIN code consisting of 4 to 6 digits and
complete your entry with the
is not available).
• When the PIN code has been detected, the code lock will
beep and the LED indicator (2) will briefly turn green. The
LED indicator (2) will then turn yellow again.
• The guest PIN code has now been saved to the previously
entered guest ID.
A guest PIN code that has already been added/saved
cannot be added again. In this case, the code lock
emits 3 short beeps and the LED indicator (2) flashes
red before turning yellow again.
The same applies if you enter a guest/user ID which is
already assigned to a guest PIN code.
• You can now assign additional guest PIN codes. Start by
entering the number of uses and follow the steps above.
• To end the adding process and exit programming mode,
press the
red to indicate that the code lock is in standby mode.
key. The LED indicator (2) will switch to constant
.
to
key (the reserved code 1234
).
41