Sygonix SY-4599778 Notice D'emploi page 36

• The code lock must be in standby mode and the LED
indicator (2) must be red.
• Enable programming mode (see section 10 "Programming",
paragraph "b) Enabling/exiting programming mode"). The
LED indicator (2) will then flash red.
Example:
• Press the
code lock is now in add transponder mode.
• Enter a user ID (a number from
• Press the
will briefly turn green, and then yellow again.
• Hold a transponder over the keypad (1). The code lock will
beep when the transponder has been detected. The LED
indicator will briefly flash green.
• Remove the transponder from the keypad.
• The LED indicator (2) will then turn yellow again.
• The new transponder will be associated with the manually
assigned user ID.
A transponder that has already been added/saved
cannot be used again for another user ID.
If a user ID was selected which is already saved to a
user transponder, the code lock will emit 3 short beeps
and the LED indicator (2) will flash red before switching
back to yellow. If this occurs, repeat the adding process
again.
36
key. The LED indicator (2) will turn yellow. The
key to confirm the user ID. The LED indicator (2)
to ).