Télécharger Imprimer la page

Moretti Forni NordCap R14G Manuel D'instructions page 13

Publicité

Les langues disponibles
  • FR

Les langues disponibles

1
TECHNICAL DATA
1.1
DESCRIPTION OF THE APPLIANCE
The oven is fitted with a baking chamber heated by means of two gas
burners with relevant heat exchangers, with a removable, rotating
tray holder carriage. The baking chamber is made of steel plate, with
an electronic type temperature regulation system. It is fitted with
exhaust fumes and temperature safety thermostats, a device to spray
water and produce steam, a suction fan that can remove fumes both
from the baking chamber and from the hood, and a glazed door with
locking handle.Cooking is extremely even thanks to controlled cycle
hot air ventilation, the flow of which is regulated by adjustable
deflectors, combined with rotation of the carriage.
1.2
DIRECTIVES APPLIED
This appliance complies with the following directives:
-
Gas appliances 2009/142/CEE (ex 90/396/CEE).
- Low Voltage Directive2014/35/EU (pursuant to 2006/95/EC)
- Directive EMC 2014/30/EU (pursuant to 2004/108/C E)
In accordance with the following regulations:
EN 203-1/A1
EN 203-2
CEI EN 60335-1 and subsequent revisions
CEI EN 60335-2-42 and subsequent revisions
CEI EN 55014-1 and subsequent revisions
CEI EN 55014-2 and subsequent revisions
CEI EN 61000-3-2 and subsequent revisions
CEI EN 61000-3-3 and subsequent revisions
CEI EN 61000-4-2 and subsequent revisions
CEI EN 61000-4-4 and subsequent revisions
CEI EN 61000-4-5 and subsequent revisions
CEI EN 61000-4-6 and subsequent revisions
CEI EN 61000-4-11 and subsequent revisions
1.3
WORKPLACES
The oven is programmed by the operator using the control
switchboards at the front, and it must be attended to while in
operation.
The door giving access to the oven is located at the front.
1.4
MODELS
There is one model available:
ROTOR14G
1.5
TECHNICAL DATA (See Tab.1-2)
WARNING!
WHEN CONSULTING TAB.1, MAKE
SURE YOU ALWAYS LOOK AT THE PART THAT
CORRESPONDS TO THE GAS CATEGORY FOR THE
COUNTRY IN WHICH THE APPLIANCE IS INSTALLED
AND AT THE EQUIPMENT MODEL ON WHICH IT IS A
PART.
In some countries, CE marking might be accepted but in any case,
national Institutions are required to inspect the appliance pursuant to
national standards and regulations.
1.6
WORKING DIMENSIONS - WEIGHTS (See Fig.1).
1.7
IDENTIFICATION
When communicating with the manufacturer or service centre,
always give the oven SERIAL NUMBER, which is affixed to the
bottom right hand part of the appliance as indicated (See Fig.2).
1.8
LABELLING
The oven is supplied with warning labels at the points shown (See
Fig.3).
B: Gas pressure rating plate for the various countries, affixed to the
oven.
C: Warning sticker for various countries, affixed to the oven.
D: Danger sticker, affixed to the oven.
WARNING!
performing any maintenance operation, disconnect the power supply
by turning off the switches fitted on the outside of the oven and/or
the leavening compartment and wait for the appliance to cool to
room temperature. Always use suitable protective equipment (gloves,
glasses...).
E: Hot glass sticker affixed to the oven.
WARNING!
On the equipment surface there is a burn risk
due to high temperature elements. For any intervention or action wait
for the appliance to cool to room temperature and always use suitable
protective equipment (gloves, glasses...).
F: Danger sticker, affixed to the oven.
WARNING!
To avoid scalding, do not use loaded containers
with liquids or cooking goods which becomes fluid by heating in
higher levels than those which can be easily observed.
WARNING!
The label referred to above dates is provided
and it is mandatory position them to a 1.6 m height from the floor is
in the oven in the cart (see Figure 3).
G: Sticker indicating mechanical
WARNING!
Moving parts.
H: Danger sticker, affixed to the oven.
WARNING!
Slippery floor.
1.9
ACCESSORIES
The oven is equipped with the following accessories:
-Set of nozzles to replace the ones fitted.
-Alternative technical rating plate.
1.10
NOISE
This appliance is a technical instrument of work and normally, the
noise level threshold at the operator station does not exceed 74 dB
(A).
UK2
Presence of dangerous tension. Before

Publicité

loading

Ce manuel est également adapté pour:

Nordcap 493300101