Télécharger Imprimer la page

Betzold 89211 Mode D'emploi page 33

Kit d'introduction à l'électronique

Publicité

Les langues disponibles

Les langues disponibles

IMPORTANT – Read carefully before using. Keep safely for later use.
The electronic instructional construction set complies with the statutory requirements for the safety of toys in accordance with the
Directive 2009/48/EC.
Warning Information for safe and correct use
Attention!
• The electronic instructional construction set is intended exclusively for use in the classroom.
• It is not suitable for children under the age of 8. This product contains a small magnet.Swallowed magnets can attract each other in the intestines
and cause serious injury. Consult a doctor immediately if a magnet has been swallowed.
• The proper assembly must be checked by an adult before use.
• Children must only use the electronic instructional construction set under the supervision of an adult.
• The construction set is not suitable for children under the age of 3 due to small parts which can be swallowed. Risk of chocking!
• Do not connect the components of the electronic instructional construction set to power sockets!
• Do not operate the components with a voltage greater than 9 volts!
• In some experiments components may become hot. Only touch these after they have cooled down.
• Avoid the direct connection of the two battery poles without a device connected between them, otherwise a short circuit occurs. Here the
electrical current in the circuit and at the source (for example, a battery) can be so high that these become hot and the risk of burn injuries
occurs on contact or hazardous substances harmful to health can escape.
• Before use ensure that all electrical components are in a good condition. Do not use damaged components!
• Operate the components only with batteries of the type AA (Mignon LR6) with 1.5 Volt. Rechargeable batteries must not be used.
• Do not use any wet or damp electrical components!
• The battery holders of this instructional construction set are equipped with protective devices for switching off in the event of a short circuit or
overload. Do not manipulate these, for example, by bridging them and replace defective fuses only with the same type supplied as specified by
the manufacturer.
The electronic instructional construction set consists of 42 parts. Batteries are not included in the scope of supply.
Advice about Disposal
Batteries do not belong in the household waste. The old batteries can be disposed of in public collection points or everywhere in places where
batteries are sold.
Operation and Storage
• Only use the electronic instructional construction set in a dry environment and with dry hands.
• Store the electronic instructional construction set out of the reach of small children.
• Operate the components only with batteries of the type AA (Mignon LR6) with 1.5 Volt. Rechargeable batteries must not be used.
Maintenance and Cleaning by the User
Disconnect the components to be cleaned from the power supply.
Wipe the components exclusively with a damp cloth. Do not use any cleaning agents. Allow the components to dry fully before their next use.
Fault Finding
Possible causes when a light bulb does not light up:
• Has the light bulb been screwed into the mount correctly?
• Has the power circuit been closed? Are all parts firmly connected with each other? Check the connections!
• Is the filament (spiral-wound filament) in the bulb in order? If necessary, replace it!
• Is the battery charged? If necessary replace it!
• Is the fuse in the battery holder defective? Replace this with the accompanying microfuse 2A flink 250V (F2AL250V)
Possible causes if when on connection the solar cell of the motor does not move:
• Halogen spotlights are not suitable as light sources, Use normal light bulbs as light sources.
In the event of further questions:
Arnulf Betzold GmbH; Ferdinand-Porsche-Str. 6; D-73479 Ellwangen, www.betzold.com; Telephone: +49 7961 - 9000 - 0 or
Telefax: +49 7961 - 9000 - 50
Spare parts and Repairs
Spare lamps, Mignon batteries, micro-fuses 2A flink 250V (F2AL250V) can be obtained from the place of purchase.
Guarantee and replacements
In addition to the legal guarantee (and without reducing it) you receive 2 years of total guarantee. That means, you do not have to prove that articles
were already damaged at purchase. In case of guarantee, contact place of purchase.
All manuals and user guides at all-guides.com
– 33 –
© Arnulf Betzold GmbH

Publicité

loading