Salicru SLC TWIN RT3 Mode D'emploi page 52

Fig. 13 to Fig. 19 show, by way of example, illustrations of a unit
with or without battery module. These illustrations provide help
and guidance in the steps to follow, but the instructions are
not intended to refer to a single model, although, in practice,
the actions to be carried out are always the same for all of them.
For all instructions regarding connections, refer to section 5.2.
5.2. INSTALLATION PROCEDURES.
5.2.1. Assembly as a rack in a cabinet.
To assemble the unit in a 19" rack-type cabinet, proceed as follows:
Fix the two fins on each side of the UPS using the supplied
1.
screws, respecting your hand.
Fig. 13. Fixing the fastening fins.
To install the unit in a rack cabinet, it is necessary to use the
2.
side guides (optional) to support it.
Place the unit on the guides and insert it all the way. Depending
3.
on the model and weight of the device, and depending on
whether it is installed on the top or bottom of the cabinet,
it is recommended that two people perform the installation
operations.
Fix the UPS to the cabinet frame using the screws supplied
4.
with the fins.
Fig. 14. Fixing the UPS module in the rack cabinet.
52
5.2.2. Installation of the unit with an optional
battery module in a rack cabinet.
Using the supplied screws, fix the two rack fins on each side of
1.
the UPS, respecting your hand. Repeat the same procedure for
the battery module.
To install the device in a rack cabinet, the support side guides
2.
(optional) are needed.
Assemble the guides at the required height, ensuring the
3.
correct tightening of the fixing screws and the proper fit in the
machining, according to each case.
Place the device on the guides and insert it all the way.
4.
Proceed in the same way for the battery module.
Depending on the weight of each unit according to the type of
5.
device and battery module, and/or whether it is installed on
the top or bottom of the cabinet, it is recommended that two
people perform the installation operations.
Fix the UPS and battery module to the cabinet frame using the
6.
screws supplied with the respective fins.
Fig. 15. Installation of the UPS with an optional battery module.
5.2.3. Vertical tower-type assembly.
Press the button on both sides of the front panel to remove the
1.
front panel.
Fig. 16. Removing the front panel..
SALICRU