Salicru SLC TWIN RT3 Mode D'emploi page 65

7.8. INTRODUCTION TO THE OPERATING
MODES.
Description When the UPS starts, the display screen of this mode is
displayed for a few seconds to boot the CPU and the system.
LCD display
Description The UPS is off and there is no output voltage available,
but it is charging the batteries.
LCD display
Description If the input voltage is within the UPS ranges, the UPS will
supply a stable sinusoidal AC voltage to the loads and will
charge the batteries.
LCD display
USER MANUAL
UPS start-up
Mode without output
AC mode
ECO mode
Description If the input voltage is within the adjustment ranges and ECO
mode is activated, the UPS supplies the bypass output voltage
in ECO mode (energy saving).
LCD display
Configure
ECO mode
Important:
The system will not allow you to enable this mode
if you have not previously transferred to Bypass.
CVCF mode
Description When the input frequency is within range, the UPS can be set
to a constant output frequency of 50 or 60 Hz. The device will
continue to charge the batteries in this mode.
LCD display
Configure
in standby
mode
Important: The system will not allow you to enable this mode
if you have not previously transferred to Bypass.
SLC TWIN RT3 0.7÷3 kVA UNINTERRUPTIBLE POWER SUPPLY (UPS)
65