Nilfisk Advance Proterra 13300109 Instructions D'utilisation page 8

ENGLISH
WARNING!
– Do not use the machine on slopes with a gradient exceeding the specifications.
– Do not tilt the machine more than the angle indicated on the machine itself, in order to prevent instability.
– Use only brooms supplied with the machine or those specified in the Instructions for use Manual. Using
other brooms could reduce safety.
– Before using the machine, close all doors and/or covers, as indicated in the Instructions for use Manual.
– Use the machine only where a proper lighting is provided.
– Working lights (optional) have to be used only to enhance visibility on the floor to be cleaned, but they do not
authorize anyone to use the sweeper in dark environments.
– If the machine is to be used where there are other people besides the operator, it is necessary to install the
pivoting light and the reverse gear buzzer (optional).
– Do not wash the machine with direct or pressurised water jets, or with corrosive substances.
– Do not use compressed air to clean this type of machine, except for the filters (see the relevant paragraph).
– While using this machine, take care not to cause damage to people and property.
– Do not bump into shelves or scaffoldings, particularly where there is a risk of falling objects.
– If the proper protective guard (FOPS) (optional) is not installed, do not use the machines in areas where there
is the risk of falling objects.
– Do not lean liquid containers on the machine, use the relevant can holder.
– The machine storage temperature must be 32 °F and 104 °F (0 °C to +40 °C).
– The machine working temperature must be 32 °F and 104 °F (0 °C to +40 °C).
– The humidity must be between 30% and 95%.
– Always protect the machine against the sun, rain and bad weather, both under operation and inactivity
condition. Store the machine indoors, in a dry place. (If applicable) this machine must be used in dry
conditions, it must not be used or kept outdoors in wet conditions.
– Do not use the machine as a means of transport, or for pushing/towing.
– The machine maximum capacity, operator's weight not included, is 365 kg (the weight of waste).
– Do not allow the brooms to operate while the machine is stationary to avoid damaging the floor.
– In case of fire, use a powder fire extinguisher, not a water one.
– Adjust the operation speed to suit the floor conditions.
– Avoid sudden stops when the machine is going downhill. Avoid sharp turns. Drive at slow speed when going
downhill.
– This machine cannot be used on roads or public streets.
– Do not tamper with the machine safety guards.
– Follow the routine maintenance procedures scrupulously.
– Do not allow any object to enter into the openings. Do not use the machine if the openings are clogged.
Always keep the openings free from dust, hairs and any other foreign material which could reduce the air
flow.
– (Only for versions equipped with dust guard system) Pay attention during machine transport when
temperature is below freezing point. The water in the system tank or hoses could freeze and seriously
damage the machine.
– Do not remove or modify the plates affixed to the machine.
– In case of machine malfunctions, ensure that these are not due to lack of maintenance. Otherwise, request
assistance from the authorised personnel or from an authorised Service Center.
– In case of part replacement, order ORIGINAL spare parts from an authorised Dealer or Retailer.
– To ensure the proper and safe operation of the machine, have the scheduled maintenance, detailed in the
relevant chapter of this Manual, performed by the authorised personnel or an authorised Service Center.
– The machine must be disposed of properly, because of the presence of toxic-harmful materials (batteries,
oil, plastics, etc.), which are subject to standards that require disposal in special centres (see Scrapping
chapter).
– While the engine is running the silencer heats up. Do not touch the silencer to avoid serious scalding or fire.
– Running the engine with an insufficient quantity of oil can seriously damage the engine. Check the oil level
with the engine off and the machine on a level surface.
– Never run the engine if the air filter is not installed, because the engine could be damaged.
– All engine servicing procedures should be performed by an authorised Dealer.
Only use original spare parts or parts of matching quality for the engine. Using spare parts of lower quality
can seriously damage the engine.
– See also the SAFETY RULES in the Engine Manual, which is to be considered an integral part of this Manual.
6
INSTRUCTIONS FOR USE
Proterra™ - 33019864
revised 08/2018