Nilfisk Advance Proterra 13300109 Instructions D'utilisation page 18

ENGLISH
PREPARING THE MACHINE FOR USE
WARNING!
On some points of the machine there are adhesive plates indicating:
– DANGER
– WARNING
– CAUTION
– CONSULTATION
While reading this Manual, the operator must pay particular attention to the symbols shown on the plates (see the Visible Symbols
On The Machine paragraph).
Do not cover these plates for any reason and immediately replace them if they are damaged.
PRE-OPERATIONAL CHECKLIST
Before Each Use:
1. Inspect the machine for damage, oil or coolant leaks.
2. Check the engine coolant level (23) (see the relevant paragraph).
3. Check the engine oil level (44) (see the relevant paragraph).
4. Check the hydraulic oil level (19) (see the relevant paragraph).
5. Check the fuel level indicator (57), if the warning light (58) is on replace the LPG tank (21).
6. Check that the pressure of all three tires is 85 psi (6 Bar).
7. Check the air filter service indicator (see the relevant paragraph).
In the driver's seat:
8. Be sure to understand the operating controls and their functions.
9. Adjust the seat with the lever (40) to allow easy reach of all controls.
10. Adjust the steering wheel height with the lever (73) in order to reach a comfortable position.
11. Insert the ignition key (65) and turn it to "I":
• Check the horn (66), hour counter (56) and headlights (70, optional) for proper operation.
• Turn the ignition key (65) to "O".
12. Check the Parking Brake (35 and 36). The brake must hold its (locked parked) setting firmly without easily being released.
(Report all defects immediately to service personnel).
13. Check the brake pedal (35). The pedal should be firm.
WARNING!
If the pedal is "spongy" or fades under pressure, do not drive the machine.
Report all defects immediately to service personnel.
14. Make sure that there are no open doors/hoods and that the machine is in normal operating conditions.
Plan cleaning in advance:
15. Plan the cleaning route. Arrange long runs, straight passes with a minimum of stopping or starting.
16. Allow a small amount of broom path overlap to ensure complete coverage.
17. Avoid making sharp turns, bumping into posts, or scraping the side of the machine.
Filling the DustGuard™ system water tank (optional)
18. Remove the plug (29) to reach the filler neck.
19. Fill the tank (4) with clean water. Do not fill the tank completely, leave a few centimeters from the edge.
MAIN BROOM
Several different main brooms are available for this machine. To select the best broom for the surface and litter to be swept, contact
a Advance Retailer.
NOTE
To install the main broom, refer to Main Broom Maintenance paragraph.
16
INSTRUCTIONS FOR USE
Proterra™ - 33019864
revised 08/2018