StarLab ErgoOne E Mode D'emploi page 28

SERVICING AND CLE ANING
Disconnecting handle from manifold
1.
Eject the pipette tips.
2.
To disconnect the manifold, pull it downward as far as possible, and
only then turn it clockwise.
After one rotation, it should no longer be pulled downward while it is
being turned.
3.
If the manifold is unscrewed pull it downward again to loosen the
magnetic coupling.
NOTE:
The manifold must be screwed into the handle counter-clockwise, until it
audibly snaps into place.
When mounting the manifold you must not pull it downward.
ATTENTION:
Improper handling can damage the unit!
Removing of nose cones and seals for cleaning or replacing
Unscrew manifold
1.
Slide off housing
2.
Unscrew cone
3.
28 · ErgoOne E-8/-12 · User Manual
Unscrew the manifold from the handle.
Turn both closures of the manifold housing
cover 90° and slide off the housing.
Push the mounting tool on the nose cone and
unscrew it